Fall is here….love the fall! Living in the desert, us desert rats are ready for Fall. I just had to share with you today this beautiful table runner made from burlap…
This isn’t a easy 1, 2 ,3 put together craft….but it is soooo worth it!!!
I tend to lean on the side of contemporary–rather than country–in most of my decor, except when I am decorating for fall. Then, I pull out the burlap, the wood, the leaves, and the twine. I love the cool air and earthy smells of fall. I LOVE the warm colors. And I LOVE this table runner.
It is fun and easy (though not quick–I’m not gonna lie). I had it in my mind as a concept, so I wasn’t entirely sure how it would work. It will be considerably faster for someone following my tutorial, than it was for me figuring it out as I went!
This is a highly customize-able craft. Once you see how it is done, you can create your own design and make it fit your aesthetic desires.
You will need:
- 1 plain burlap table runner. I made mine by hemming the sides of a strip of burlap to fit my table.
- 1/4 -1/2 yard of burlap in 2-3 complimentary tones (one can match runner)
- Tacky Glue
- Jute Twine
- 1/2-1 yard Heat-n-Bond or similar product
I stuck with earthen tones for my burlap. I tried Elmer’s Glue-All also, but I don’t recommend it. It was too runny for the purpose. Tacky Glue is just that–tacky.
This worked well enough, but I wouldn’t hesitate to by the not “lite” version since this is burlap. Any bonding that was less-than-secure after ironing this on was taken care of by the gluing step.
1. Find or create some pumpkin and leaf stencils/patterns out of paper. I traced some leaf decorations I already had and free-handed the pumpkins. Many templates are available online.
2. Pin your leaf and pumpkin patterns to some of the coordinating burlap and cut them out. I didn’t end up liking the way the maple leaf design looked on my runner, but I plan to use it on a pillow!
3. To make the coordinating parts on the pumpkin: Cut a pumpkin shape out of two different colors of burlap. Here the white burlap is on the bottom, the brown on top. Trace lines as shown to divide the pumpkin into 7 curved strips. Cut the strips out. Repeat this for each pumpkin you are making.
4. Lay out your design. I played around with mine a lot. I originally planned to do this “applique” over the entire runner, but because I have a fairly large center piece I use in the fall, I decided to just put it on each end.
5. Read the directions on the Heat-n-Bond. I will walk you through it as well, but reading it will help. Beginning with the top layer of the applique (here, the pumpkin strips) bond the Heat-n-Bond to the back (paper will still be attached).
**Place a piece of disposable fabric or paper over your ironing board when you are working with the iron on adhesive
The glue will get on everything below when you turn it over to iron. (I should have shown this so you weren’t looking at my old, stained ironing board cover!)
6. Cut out the pieces with the paper backing still on.