Follow my blog with Bloglovin
Over the past few days, I have been putting together a couple of centerpieces, Firecracker Centerpiece on the left of the picture, and the Flower Centerpiece on the right. I also made 2 candle holders from wood posts, and a pinwheel garland…lots of fun and easy for you to also create! Almost everything was recycled items.
Let’s start with the firecrackers and pinwheel centerpiece above on the left side . It is decorated with firecrackers, pinwheels a huge rocket getting ready to take off and 3 solar lights to keep it lit up at night. For the firecrackers, here’s what I did… for the 3 smaller firecrackers in front, I used 4 Toilet paper rolls. Three of them were used for the firecrackers and 1 to cut lengthwise and use to trace the circles for the tops. I put a hole in each circle and pulled the rope thru.
I took 3 coordinating papers and cut and glued them onto the 3 TP rolls. I then made the pinwheels that are in the Firecracker Centerpiece.
Patriotic Candle Holders:
I had some 4×4 post pieces left over from building the pergola. I cut 2 to the size I wanted. I then took Rustoleum White Blossom and sprayed the whole post. Tip: I always spray white first so the colors that I paint on top will pop!
I made stripes with Frogtape 1 7/8″ where I wanted to paint the red stripes.
I removed the tape. Then painted the top blue. Added Stars to 2 sides on blue
Flower Centerpiece, think it is adorable and makes a cute centerpiece! To make this you start with about 8 empty toilet paper rolls, or a couple of paper towel empty rolls.
You can see below. To make the flowers, you cut the toilet paper roll in half. I then cut each in half again to make 4 pieces. There you have your petals. You put 4 of them together with white glue, pin with paper clip, clothespin, etc till they dry. For the leaves, you cut one of the pieces 3 times.
You can see above…the thin ones to the far right are the leaves. I painted them easily with acrylic paint. I tried once spray painting, but didn’t take the color well. I put a Rhinestone, coordinating paper in the center of flowers.
You can use a skewer, straw or stick for the stems. I then shredded up left over paper from the firecrackers and previous projects. I took a Pretzel container, you know those big plastic ones, and cut off about 2/3. I then took Mod Podge and spread on the outside of the plastic. I then took a couple of napkins with the flag on it, and placed them on careful not to wrinkle too much.
To make the Q Tip sparkler….. You glue 4-5 Q Tips to the end of your skewer/straw at a angle. Paint one color. Add some of the foil shreds inside between the Q Tips.
Garland Pinwheels: For this project you will need Scrapbook pages in patriotic colors. You start by cutting the paper in half. Take one half and start at the widths end, and fold under and fold back over like you’re making a fan,
Then you fold it in half again, and press down on the folded part really hard with your fingers to strengthen that fold. Be sure the ends line up with each other and glue the ends together. You can use Aleenes tacky glue or hot glue.
Now take the two ends and bring together and glue…it will look like this:
Then I decided a star would be perfect in the middle
Added glitter around the edges!
Then I started making a bigger one….
This one is bigger. What I did was cut the blue scrap paper in half again, make the folds on both, then glue them together. You glue them just in the middle, making a bigger fan. Then you do the same with a contrasting paper. Then you glue the blue to the red on both sides.then I added glitter
I continued to make a few of these with different scrapbook pages. I added a couple to the firecracker centerpiece, and the rest went on a garland I made in the background.
So that is all of the different crafts I did to make this wonderful table setting:
Follow my blog with Bloglovin